User manual

6
A backup can only be restored on the same device.
At the end of a backup, the device will shut down and restart automatically.
If you want to rename a backup file previously executed, it is recommended not to insert spaces in the new name.
“RESTORE DATA” To restore data previously saved through “BACKUP DATA” function. Connect the USB device in which data was
saved and then activate the function.
“SYSTEM INFO” To display:
Installed software version
The amount of occupied space on the internal storage unit
MAC (Machine Code), unique for each device
“SOFTWARE UPGRADE” To update vPed software version. When in possession of an update (files with ". Upg" extension ), copy it
to an USB device than connect it to one of the 4 USB ports available on the left side of vPed. Then select the update that will be
displayed (e.g. vPed-xxx.upg) and launch "SOFTWARE UPGRADE" utility. After a few seconds, when the update will be installed,
vPed will restart automatically.
“REMOTE ASSISTANCE” With the help of this function you can receive support directly from the customer service of vPed. To enjoy
this service requires a broadband connection and vPed connected to the network via the LAN. It 'possible that the network connection
may be required during the activation of certain plugins.
“CLEAR ALLA DATA” to delete all data, including plugins and programs (presets) saved by the user. Note that you will also delete
the factory pre-installed data.
“BRIGHT SUN MODE” mode if you use vPed in particularly bright or with the device exposed to direct sunlight. The mode also lowers
to a lower value of the CPU clock vPed. Restarting vPed, the mode "BRIGHT SUN MODE" will be automatically disabled.
INSTALL / UNINSTALL EFFECTS
(Installing / uninstalling plugins)
vPed supports installations of VST / VSTi whether they are composed of simple "dll" which installation with "Setup" procedure.
Installation via "dll" files
If you install a plug composed only by a "dll" file, copy it to a USB device
and connect it to a USB port of vPed. Then go to MENU section by pressing
and holding for at least one second "PAGE / ENTER" footswitch, then select
"UTILITY" to enter the section. The menu of options shows as first item
“INSTALL EFFECTS”. Press "PAGE / ENTER" to enter the screen that
shows the contents of the USB device. Locate the "dll" relates to the effect
that you want to install, highlight it using the buttons corresponding the
arrows , then again press "PAGE / ENTER",
or, alternatively, double click the left mouse if connected.
This screen there is also the button "BROWSE" that allows you to enter the structure of vPed.
Note: , as reported by the message that appears subsequently pushing the "BROWSE" button, can't be held in any way
responsible for any malfunction or other due to changes executed in the section which is accessed subsequently pressing the button
corresponding to "BROWSE", therefore use caution and knowledge of the facts by applying changes to this section.
A message will ask you to confirm the installation of the plugin.
Press the buttons corresponding to "YES" to continue or "NO" to
cancel. Afterwards the confirmation of installation, press "BACK"
several times (depending on the location of the plugin), until you
see where vPed will ask to confirm by the graphical display of the
plugin. Press the button "CONFIRM" to complete the installation.