User manual

3
Right side panel. Audio connections and footswitches inputs
On the right side of vPed there are several audio connectors. In/Out and control connectors description is shown on the front panel to
ease use.
1
2
8
3
4 5 6 7
1) Guitar / Bass input sensitivity selector. "HI" is preferred for connecting instruments with passive “single coil” pickup and "LOW"
is more suitable for humbuker pickups or, any instruments with built-in pre-amplification.
2) ¼” jack input, for guitar/bass.
3) Balanced microphone input.
4) 2 pseudo-balanced XLR outputs, respectively left and right channels. In case you want to use only one output, use one of the
two connectors, remembering to set the audio output in MONO mode (MenuGlobal SetupMono Output). Note that all
outputs are active simultaneously, allowing you to send the output signal of vPed to multiple inputs (e.g. guitar / bass amplifier
and P.A. system).
5) 2 jack ¼” unbalanced outputs, respectively left and right channels. As already mentioned above, if you want to use only one output,
use one of the two connectors, remembering to set the audio output in MONO mode (MenuGlobal SetupMono Output).
6) Assignable external expression pedal inputs (not included).
7) Assignable external inputs switches (not included).
Left side panel. Connections
A) Power supply connector
B) 4 USB2 ports
C) HDMI connector. By connecting an external video device you can replicate what is shown on the display of vPed. From this
connector you can also get a 24-bit/96 kHz digital audio output
D) RJ-45 LAN port with LED status indicators
E) Aux stereo audio input
F) Headphones connector
To the right headphone output there is the On / Off power button,
On the right of the front panel of vPed, there are 2 knobs and a foot switch:
, which assumes the function adjusting the values depending on the selected parameter,
and also other tasks always according to the type of editing that is being carried. When you are on the
main screen of a board, you can assign to the knob PAGE, the control of a specific plugin parameter
chosen by the user.
, to adjust the global audio output level
, characterized by the red illumination. Pressing this footswitch once, you access
alternately the first 4 (1/4) or following 4 (5/8) slots available for loading effects. To return to the first
group of slots (1/4), press the button again "PAGE / ENTER".
Description of the functions and usage
Turning the power on, after a few seconds, the screen related to the first 4 available effects will be
displayed, while pressing the last foot button on the right once (PAGE / ENTER), you will see the
screen that shows the other 4 available effects. The activation times depend on the characteristics of
the last board loaded at power off the device.
In the middle of the top bar of the main screen, there is the description of the group of slots displayed:
Displays the first group of plugins assigned in positions from 1 to 4
VALUE
VOLUME
PAGE/ENTER