Specifications

QUADRAPADDLE SIGNAL CONTACTS AND MODULES USER’S MANUAL: SECTION 6 VIRGINIA PANEL CORPORATION
1/26/10
6-3 For more information visit vpc.com
RECEIVER FRAME
STYLE
RECEIVER
FRAME
THICKNESS
STAND-OFF
CONFIGURATION
ITEMS TO
BE USED
9025, 9025TR, 9050,
9075, SL4, S6, G12,
and G12x
0.545
[13.84]
⅛" [3.18 mm] stand-off
per mounting screw
Item 
Small 90 Series
(3,6,10), G2, G6,
G10, and G18
(NON-PCB)
0.365
[9.27]
5
/
16
" [7.94 mm] stand-off
per mounting screw
Item 
G10 (PCB) and G18
(PCB)
0.250
[6.35]
Both ⅛" [3.18 mm] and
5
/
16
" [7.94 mm] stand-off
per mounting screw
Item 
Table 1.
PCB ADAPTER INSTALLATION AND REMOVAL INSTRUCTIONS,
CONTINUED
4. Access the rear of the receiver frame and install the 4-40 stand-offs
to the 4-40 X 1¼” module retaining screws according to Table 1
(Figure B).
5. Align the PCB adapter’s two threaded retaining sockets with the
4-40 x 1¼” module retaining screws with stand-offs installed (Figure
B). Ensure that Position 1 on the adapter corresponds with Position 1
on the module.
6. Using the
3
/
32
Allen wrench, carefully install the PCB adapter by
tightening the retaining sockets, turning each no more than 1½
to 2 full revolutions before alternating to the other socket. Repeat
this step until the PCB adapter is rmly engaged with the receiver
module, taking care not to over-tighten. Torque screws to 4 in-lbs
[0.45 Nm].
7. To remove the PCB adapter from the receiver frame and module,
use the same alternating method of 1½ to 2 turns until PCB assembly
is fully disengaged.
Figure B. Exploded view of assembly.
VPC RECEIVER FRAME
(
NOT SUPPLIED)
SEE TABLE 1
VPC RECEIVER MODULE
CUSTOMER SUPPLIED PCB
SHROUD ASSEMBLY
STAND-OFFS
PART # 510 150 130
1
2
QUADRAPADDLE SIGNAL CUSTOM RECEIVER PCB ADAPTER
INSTALLATION AND REMOVAL
PART # 510 150 152 / 510 109 315
Dimensions shown: [millimeters]
inches