User's Manual

20
12.0 Start-Up Guide
The following indicators and actions are required to start and configure the Vpatch System.
Press ‘D’ to switch on Vcell and wait for green LED and 1 beep.

START UP VCELL LED VCELL BUZZER VPOD BUZZER
Setup 1 flash
Setup complete 1 sec
Single
beep

If PAIRING is not required, switch on the Vpod immediately and skip to NETWORK.
To PAIR devices, press and hold ‘F’ on the Vcell until ‘E’ begins to flash.
Then switch on the Vpod and press and hold ‘A’ until 1 long beep is heard.
This indicates successful pairing.

PAIRING
V
CELL LED
V
CELL BUZZER
V
POD BUZZER
While searching
Fast
flashing
Fast
beeping
Successful pairing
Successful
pairing
Long
beep
Default Settings reset
Vcell moves on to next
stage (see next table)
Single
beep

The Vcell will then immediately connect to the Network. This LED sequence may vary slightly.

NETWORK
V
CELL LED
V
CELL BUZZER
V
POD BUZZER
While searching
Slow
flashing
Successful
connection
For duration
of action

The Vcell will then check that it is in range with the Vpod.

RANGE
V
CELL LED
V
CELL BUZZER
V
POD BUZZER
In Range

The Vcell will check for configuration settings and transfer them to the Vpod.

CONFIGURATION
V
CELL LED
V
CELL BUZZER
V
POD BUZZER
Sending configuration
data
Three
beeps

The green LED on the Vcell will light up, indicating that the devices are in range.
The system is now ready for use.