User`s guide
Installation and Setup
2-16
5100-A2-GB21-00
November 1996
Saving Configuration Settings
When you first install the software or whenever you change switch settings, you
need to save these settings to the
protocol.ini
file. If you are using more than one
TCP/IP package (e.g., Windows TCP/IP, Trumpet, Chameleon, etc.) on the same
machine, you need to save the switch settings to the
protocol.ini
file for each
package. If you attempt to save but the file cannot be found or you need to
change the path, refer to
Checking/Setting Protocol.ini Path
for information.
Procedure
To save the configuration settings:
1. Select File from the HotWire
main menu.
2. Select Save.
The Save window appears.
This window uses the
standard Windows user
interface conventions.
3. Verify the pathname for the
protocol.ini file (not applicable
to Windows 95).
4. Click on one of the following:
— OK to accept the
parameters and return
to the main menu.
— Cancel to close the window without accepting any values and return the
main menu.
— Help to access screen help.