User`s guide

Installation and Setup
2-12
5100-A2-GB21-00
November 1996
Checking Installation
Once you have installed the card and the utility, you can check card installation
using the Diagnostics Utility.
 Procedure
To check installation:
1. Enter Windows/Windows 95.
2. Double-click on the HotWire program icon to access the following main
menu. For a complete description of this menu, refer to Chapter 3.
3. Select Recommend Base Address from the Configuration menu.
Typically, if the software detects the HotWire DSL card, you will see only one
base address listed in the Available Base Address window. This address
matches the address set on the card and should match the address you set
in the Hardware Setup window.
4. Click on Exit to close the Available Base Address window.
5. Perform the following five procedures:
—
Verifying/Changing Switch Settings in Software, see page 2-13
—
Verifying/Changing Line Speed in Software, see page 2-14
—
Checking/Setting Protocol.ini Path, see page 2-15
—
Saving Configuration Settings, see page 2-16
—
Checking Card Status, see page 2-17
6. Quit the utility by selecting Exit from the File menu.