Specifications

SELF CLEANING BLENDER BIN OPTION

1. Turn OFF station on vacuum loader.

2. Remove material through drain tube on bin and run BIN EMPTY MODE for that specified

bin.

3. Close slide gate on bin.

4. Hook up shop vac or small self contained vacuum hopper to 1-1/2" vacuum stub on bin and

start it.

5. Go to control panel and start the air pulsing.

6. Allow to cycle for several minutes and shut off.

7. Shut off shop vac.

8. Open slide gate.

9. Do visual inspection and wipe out any remaining residue.

10. OK to reload material.

11. When all bins are cleaned go to MANUAL DUMP MODE and dump material from weigh

hopper into mixer.

12. With mixer OFF open inspection doors and attach shop vac to vacuum take off.

13. Start shop vac and visually verify all material has been removed, wipe out remaining residue.

14. Secure all hoses and doors to mixer.

15. OK to start next blending batch.

NON SELF CLEANING BINS

1. Turn OFF station on vacuum loader.

2. Remove material through drain tube on bin until material falls below drain tube then close it.

3. Run BIN EMPTY MODE until all material is out of the bin into the weigh hopper.

4. Open bin access door and wipe out any remaining residue.

5. Go to MANUAL DUMP MODE and dump material from the weigh hopper into mixer.

6. Go to previous page lines 12 to 15.

REMOVABLE BINS

1. Turn OFF Station on vacuum loader.

2. Unplug level sensors for bin to be cleaned and close the slide gate.

3. Tilt vibratory feeder down so that tube is parallel to floor.

4. Go to BIN EMPTY MODE on blender panel, select the desired bin and start. Run until all

material has been fed into the weigh hopper.

5. Loosen thumbscrews on the bin base and slide bin out. Dump material out and wipe clean.

6. Replace bin, tighten thumbscrews and connect level sensors.

7. Remove vacuum hose from mixer vacuum take off. Attach shop vac and turn ON.

8. Go to MANUAL DUMP MODE, dump material into the mixer and vacuum it out.

9. Loosen wing nuts on mixer and remove the back plate.

10. Empty mixer out and clean it.

11. Replace back plate and mixer. Tighten wing nuts. Blender is ready for next batch.