User`s guide

Installing POTS Splitter at Customer Premises
B-2
5100-A2-GB20-00November 1996
Use the following procedure to wire the POTS splitter.
 Procedure
1. Attach the splitter at a distance from the Telephone Network Interface that
makes it convenient to run connecting leads.
2. Access the customer side of the Telephone Network Interface as shown in
Figure B-2.
3. Connect the tip lead of the DSL card cable to G1.
4. Connect the ring lead of the DSL card cable to R1.
5. Connect G1 to T1.
6. Connect R1 to T2.
7. Connect the tip lead of the customer telephone to T3.
8. Connect the ring lead of the customer telephone to T4.