User`s guide

B-1
5100-A2-GB20-00
November 1996
Installing POTS Splitter at
Customer Premises
B
How to Install the POTS Splitter
The following procedure describes how to wire a HotWire POTS Splitter at a
customer site. It does not specify the specific hardware to use. Consult your
company’s specifications for that information. However, it is recommended that
you use the same type of two-conductor cable that is used for the pole-to-house
connection to make the connection between the Telephone Network Interface
and the POTS splitter. Also, use EIA/TIA Category 3 cable between the DSL card
and the POTS splitter.
Figure B-1 presents a schematic view of the circuit. Figure B-2 illustrates how to
wire the POTS splitter.
To
Customer
Telephones
Primary
Surge
Protection
(2)
DSL Card
POTS
Splitter
T1
Tip
T2
Ring
T3
Tip
T4
Ring
Network
Demarcation
Point
To
Subscriber
Loop
496-15024
Figure B-1. Schematic of POTS Splitter Installation