User`s guide

Configuring and Managing the Card
4-8
5100-A2-GB20-00
November 1996
Board ID (CO and CP Cards)
The Board ID screen shows identifying information about the CO and CP cards.
Board ID Display
Parameter
Description
Channel Number User-supplied number that identifies the channel. (See
Setting I/O Base Address in Chapter 2.)
Software Version (CO card
only)
Version number of the central management utility.
Firmware Version Version number of the firmware currently loaded.
Hardware Release Release level of the card.
Base Address (CO card
only)
The I/O base address as set by DIP switches on the card.
(See
Setting I/O Base Address in Chapter 2.)
MAC Address The MAC address of the CO card.
Model Number Model number of card.
DSL Firmware Version Version number of the firmware related to DSL chip set.
Serial Number Serial number of the card.
Diagnostics
The Diagnostics screen gives you access to loopback tests to run on the card.
Chapter 6,
Diagnostics, discusses the use of the loopbacks in troubleshooting.
Diagnostics Display (1 of 2)
Parameter
Description
Channel Number User-supplied number that identifies the channel. (See
Setting I/O Base Address in Chapter 2.)
Locate LED Flashes the LED on the card selected by the channel
number (see
Setting I/O Base Address in Chapter 2). The
choices are:
 0=Turn flashing off
 1=Turn flashing on
 2=Turn flashing off after 30 seconds
Clear Status Counters Type Y(es) to reset the operational status and error status
counters. Type N(o) to keep the existing count. (See
Operational Status (CO Cards), page 4-4.)