User`s guide

Configuring and Managing the Card
4-4
5100-A2-GB20-00
November 1996
Configuring and Managing the Card
The central management utility enables you to:
 Monitor the status of the CO card and the CP card with which it
communicates by using the Operating Status and Error Status menus
 Identify the version numbers associated with the CO and CP cards by
selecting the Board ID menu
 Run loopback tests on the cards by selecting the Diagnostics menu
 Cause a firmware reboot of the card by selecting the Reset menu
 Upgrade the card’s firmware by selecting the Firmware Upgrade menu
 Set DSL mode by selecting the Configure DSL Cards menu
 Set MAC and IP filter addresses by selecting the Set Filters menu
The sections that follow describe these selections.
Operational Status (CO Cards)
The Operational Status screen displays the amount of data sent and received by
the CO cards.
Operational Status Display (CO) (1 of 2)
Parameter
Description
Channel Number User-supplied number that identifies the channel. (See
Setting I/O Base Address in Chapter 2.)
Ethernet Packets Received Number of Ethernet packets received by the CO card from
the LAN segment.
Ethernet Packets
Transmitted
Number of Ethernet packets transmitted from the CO card
to the LAN segment.
Ethernet Octets Received Number of Ethernet octets received by the CO card from
the LAN segment.
Ethernet Octets
Transmitted
Number of Ethernet octets transmitted from the CO card
to the LAN segment.
DSL Packets Received Number of DSL packets received by the CO card from the
CP card.
DSL Packets Transmitted Number of DSL packets transmitted from the CO card to
the CP card.
DSL Octets Received Number of DSL octets received by the CO card from the
CP card.
DSL Octets Transmitted Number of DSL octets transmitted from the CO card to the
CP card.