User`s guide

Configuring and Managing the Card
4-3
5100-A2-GB20-00
November 1996
(The Set Filters menu enables you to configure multiple MAC and IP filter source
addresses, as well as individually set the filter states for these addresses to On
(enable) or Off (disable). Use the left and right arrow keys to scroll through these
addresses and state selections. See page 4-12 for a complete description of the
Configure DSL Cards menu items.)
Read-Only Menus
The following menu items return read-only information after you input a channel
number:
 Operational Status
 Error Status
 Board ID
The figure below shows an example of a read-only menu.
******************************************************************************
* Operational Status (CO) *
******************************************************************************
Channel number 6
Ethernet Pkts Received 76945
Ethernet Pkts Transmitted 7116
Ethernet Octets Received 423389358
Ethernet Octets Transmitted 555567
DSL Pkts Received 7115
DSL Pkts Transmitted 268140
DSL Octets Received 569727
DSL Octets Transmitted 206647187
MAC Broadcast Pkts Rcvd 0
MAC Broadcast Pkts Xmtd 0
Link Up
Ethernet Link Integrity Good
______________________________________________________________________________
Channel Number (0-17) >>
******************************************************************************
* Use Esc to return to the main menu. Use Ctrl-R to refresh the screen. *
******************************************************************************
To select a card, type the channel number in the input field (>>) and press Enter.
To return to the main menu, press Esc.
To update the information on the screen, press Ctrl-R.