Manualshelf

User`s guide

ManualsBrandsvpacket ManualsComputer equipmentHotwire 5100
31323334353637383940
Configuring and Managing the Card
4-2
5100-A2-GB20-00
November 1996
Menus That Require Input
The following menus require that you input information (other than the channel
number):
H Set Filters
H Configure DSL Card
H Diagnostics
H Firmware Upgrade
The figure below shows the Filters menu.
******************************************************************************
* Filters *
******************************************************************************
Channel Number (0-17) : 6
MAC Filter Source Address 1 : 00:00:00:00:00:00
IP Filter Source Address 1 : 110.112.113.114
MAC Filter State 1 (1=On, 0=off) : 0
IP Filter State 1 (1=On, 0=off) : 0
MAC Broadcast Filter State (1=On, 0=Off : 0
Unknown Protocol Filter State (1=On, 0=Off) : 0
Save the Changes ( Y(es) or N(o) ) : N
******************************************************************************
*Channel Number (0-17) >>
******************************************************************************
*Comments:
******************************************************************************
******************************************************************************
*Use Del to erase entry. *
*Use Esc to return to the main menu. Use Ctrl-R to refresh the screen. *
******************************************************************************
" Procedure
To input information:
1. Use Enter to move through the fields.
2. Type a parameter in the input field (designated by >>).
3. After making your choices, type Y(es) in the Save the Changes field and
press Esc to save your changes and return to the main menu.
If you
do not
want to save your changes, type N(o) in the Save the Changes
field and press Esc to return to the main menu.
Pressing Ctrl-R updates the information on the screen.
A Comments field gives you status information about the operation of the screen.