User`s guide

Installing and Connecting the Card
2-12
5100-A2-GB20-00
November 1996
c:\Windows\system32\drivers\genport.sys (or
c:\WinNT35\System32\drivers\genport.sys).
9. Type a:\regini a:\genport.ini.
10. Reboot the CO PC.
11. Insert the floppy labeled CO PC Windows NT Central Management Utility
Software into an available floppy drive (drive A is assumed in Step 13).
12. Select File→Run from the Program Manager menu.
13. Type a:setup.exe and click the OK button.
Installing the SNMP Agent Software
Before installing the SNMP agent on the CO PC, be sure the following
prerequisites are met:
H Windows NT 3.51 workstation or server operating system.
H A LAN NIC (Network Interface Card) installed in the CO PC with proper driver
for the card.
H A TCP/IP protocol stack (included with NT) installed and configured, bound to
the NIC.
H The kernel driver provided with the product must be installed (page 2-11).
H If the SNMP agent provided with Windows NT is installed, it must be
deactivated. To check for its installation, look under the Main group, under the
Services Icon. If it is installed, stop it and change the startup to manual so it
will not start automatically.
Use the following procedure to install the SNMP agent software.
1. Insert the floppy labeled CO PC Windows NT SNMP Agent Software into an
available floppy drive (drive A is assumed in Step 13).
2. Select File→Run from the Program Manager menu.
3. Type a:setup.exe and click the OK button.
Since the SNMP agent is typically running in the background, the following
procedure is recommended to ensure good response time to SNMP requests:
" Procedure
1. Under the Main group, double click on Control Panel, and then on the System
icon.
2. On the System dialog box, click on the Tasking... button.
3. Select Foreground and Background Applications Equally Responsive.
Follow the steps described in Chapter 5 to configure the SNMP Agent.