User`s guide

Installing and Connecting the Card
2-6
5100-A2-GB20-00
November 1996
Connecting to the LAN Network

Procedure
1. Plug the end of an 8-pin modular cable into the J1 Ethernet connector of the
CO card.
2. Plug the other end of the cable into your LAN hub connector.
Connecting to the POTS Network
The HotWire DSL product comes with one of two types of POTS splitters:
rack-mounted or standalone. The installation procedures for these two types of
splitters follow.
Connecting to the POTS Network Using Rack-Mounted POTS Splitters

Procedure
1. Install the POTS splitter rack and its multi-pin blocks at a distance from the
CO PC and POTS lines so that it is convenient to run connecting leads.
2. Insert POTS splitter cards into rack.
3. Connect rack connector P2 to multi-pin block #1; connect rack connector P3
to multi-pin block #2. (P2 connects POTS splitters 1 through 12 to block #1.
P3 connects POTS splitters 13 through 24 to block #2. There are two splitters
per card.)