User`s guide

2-1
5100-A2-GB20-00
November 1996
Installing and Connecting the
Card
2
Package Contents
The HotWire DSL CO product consists of:
H CO DSL card
H HotWire DSL CO Product Disks
H HotWire DSL POTS Splitter
H User’s guide
Installation Steps
" Procedure
To install the HotWire DSL CO product, follow these steps:
1. Set the I/O base address of the card by setting dual in-line package (DIP)
switches on the card (page 2-2).
2. Set all hardware interrupt request (IRQ) switches to off (page 2-4).
3. Install the card into the PC (page 2-4).
4. Cable the card to the local LAN network (hub) (page 2-6).
5. Cable the card to the POTS splitter (page 2-6).
6. Cable the POTS splitter to the subscriber loop and CO switch (page 2-6).
7. Install the HotWire DSL CO product software (page 2-11).
8. Configure (if necessary) the DSL mode and MAC and IP filter addresses
using the HotWire DSL Central Management Utility as described in
Chapter 4,
Configuring and Managing the Card .
9. Configure the SNMP Agent as described in Chapter 5,
Configuring the SNMP
Agent
.