Installation guide

Acme Packet 6100 Hardware Installation and Maintenance Guide 91
Postinstallation After the Solid State Drive has been installed in the Acme Packet 6100, you can close
the chassis and reinstall it in the equipment rack.
Attaching the Lid Use a #2 Phillips-head screwdriver for al
l chassis cover and side screws.
1. Set the lid on top of the Acme Packet 6100 chassis. The stickers are positioned
at the chassis rear.
2. Screw the eight countersunk screws into
the top of the Acme Packet 6100 to
secure the chassis cover to the chassis. The following is an image of the top of
the chassis without any screws.
REAR
FRONT
3. Continue securing the chassis lid with four screws on each side.
LEFT SIDE
RIGHT SIDE