Installation guide

90 Acme Packet 6100 Hardware Installation and Maintenance Guide
5. Hold the SSD in one hand, and the SATA connector in the other, and gently
disconnect the two. Note that the SATA cable should remain attached to the
motherboard.
Screw
SATA
Connection
to SSD
SATA
Connection
to Motherboard
REAR
FRONT
Bases
Figure 6 - 122: After SSD removal
Replacing the Solid
State Drive
1. Exchange the current SSD for the replacement, then re-attach the SSD to the
SATA cable. The connector is keyed, so make sure the gap in the connector is
lined up with the key in the SSD.
2. Push down on the part of the SATA connect
er attached to the motherboard to
check to make sure the SATA cable is seated properly to the motherboard.
3. Line up the screw mounts on the SSD with the screw bases, and tighten the
scr
ews. Be careful not to over-tighten the screws.