Installation guide

Acme Packet 6100 Hardware Installation and Maintenance Guide 87
2. Set these screws aside.
REAR
FRONT
3. Unscrew the seven countersunk screws on the top of the Acme Packet 6100 that
hold the chassis cover to the chassis. The following is an image of the top of the
chassis.
4. Set the lid and screws aside.
5. Lift the chassis lid off of the chassis and set aside.
Removing and
Replacing the
Solid State Drive
Caution Before handling the Solid State Drive, ground yourself using an
ESD wrist strap or other comparable grounding system. Failure
to do so could damage the Solid State Drive or the Acme
Packet 6100.
Identifying the Solid
State Drive
Once the Acme Packet 6100 is open, replacement is straightforward. The Solid State
Drive (SSD) attaches electrically to the Acme Packet 6100 motherboard by a
standard 2.5” SATA connector. In addition, it is secured to the motherboard by four
screws.