Installation guide

86 Acme Packet 6100 Hardware Installation and Maintenance Guide
Figure 6 - 118: Figure 2 - 35: Left chassis slide.
3. Remove the the two countersunk screws on the left rear side by using a #1
Phillips-head screwdriver.
4. Repeat steps 1 - 3 on the right side of
the Acme Packet 6100.
5. Set the rack ears and screws aside
Opening the Chassis The chassis lid is secured to the chassis by 15
screws. Remove the screws and lift the
chassis lid off the chassis.
Caution Before opening the Acme Packet 6100, ground yourself using
an ESD wrist strap or other comparable grounding system.
Failure to do so could damage the Solid State Drive and the
Acme Packet 6100.
Note: Use a #2 Phillips-head screwdriver for all chassis cover and side
screws.
1. Unscrew the four countersunk screws on ea
ch side of the Acme Packet 6100 that
hold the chassis cover to the chassis.
LEFT SIDE
RIGHT SIDE
Figure 6 - 119: Figure 2-36: Countersunk screws on the sides.