Installation guide

Acme Packet 6100 Hardware Installation and Maintenance Guide 81

5. Grasping the SODIMM between your thumb and index finger, pull the

component out of the slot as shown in the series of images below.

Figure 6 - 114. Removing the SODIMM (l-r)

6. Place the SODIMM in an ESD-safe location.

7. Repeat steps 3 through 6 to remove the SODIMM from the bottom slot.

Installing the

SODIMM(s)

The following procedure describes how to install the SODIMM(s) onto the

Acme Packet NIU card.

Prerequisites:

• Plac

e the new SODIMM(s) in an ESD-safe location.

• W

ear an ESD wrist strap or take similar equivalent actions to prevent static

damage to the NIU card or other ESD-sensitive components.

• N

ote the location of the SODIMM connectors on the NIU card.

To install the SODIMMs:

1. Remove the NIU card as directed in this guide.

2. Place the NIU card onto an ESD-safe location.

3. Orient the replacement SODIMM so that the key on the component is

ned up as highlighted in red in the following.

Figure 6 - 115. SODIMM Key Location

4. As shown below, slide the component into the SODIMM slot at a 25-

degree angle by grasping the SODIMM between your thumb and index

finger and pushing the component into the slot until the SODIMM is

firmly and completely seated.