Installation guide

Acme Packet 6100 Hardware Installation and Maintenance Guide 59
System access in the following procedure uses the default User and Superuser
passwords. If you do not have the default passwords, please send an email to
[e-mail].
1. At the ACLI Password prompt, enter the default system User password
and press <return>. Your entries are not echoed on the screen.
User Access Verification
Password:
ACMEPACKET>
From the User prompt you can view various configuration states and
operating statistics on the Acme Packet 6100 and perform configuration
tasks.
2. Type enable and press <return> to enter Superuser mode. The prompt to
enter the superuser password appears.
ACMEPACKET> enable
Password:
3. Enter the Superuser password and press <return>. The system prompt will
ends with a pound sign instead of a closed-angle-bracket to let you know
are in Superuser mode.
Password:
ACMEPACKET#
4. You can now begin configuring your Acme Packet 6100. Refer to the Acme
Packet Configuration Guide to learn how to establish an IP address for your
Acme Packet 6100.
If you have any questions about booting or powering on your system, contact
your customer support representative.
Formatting the
Solid State Drive
After the initial log on to the Acme Packet 6100, you must format the Solid State
Drive. Details on file system designs and the formatting procedure may be found in
Chapter 9, File System Maintenance of the Maintenance and Troubleshooting Guide
for your software release.