Installation guide

50 Acme Packet 6100 Hardware Installation and Maintenance Guide
DC Power Cord
Installation
This section shows you how to install a DC power cord.
Caution Use a 30 Amp fused circuit for each DC power supply.
Caution Refer to the power supply’s polarity label when connecting it to
a power source. Failure to do so can result in equipment
damage or serious injury.
Important: This equipment is intended for installation in Network
Telecommunication Facilities.
To install the DC power cords in the Acme Packet 6100:
1. Set the System Power switch to the Stby position to cut off power to the
Acm
e Packet 6100.
AlarConsole
System
Power
On
Stby
Stby
Dis
OUT
IN
OUT
IN
Figure 4 - 74. DC Power Supplies (left) and System Power Switch (right)
2. Locate the two DC power cords shipped with your Acme Packet 6100.
Choose one power supply to work on first.
3. Connect the plug from a 3-conductor power cord into the connector
locat
ed on one of the DC power supplies.
Console
System
Power
On
Stby
Stby
Dis
OUT
IN
OUT
IN
Figure 4 - 75. Plug in One DC Power Cord