Installation guide

14 Acme Packet 6100 Hardware Installation and Maintenance Guide
Network
Management Ports
The Acme Packet 6100 has three network management ports located on the left
side of the chassis, labeled Mgmt 0 Mgmt 1 Mgmt 2. These 10/100/1000 Base-T
Ethernet ports are used for EMS control, RADIUS accounting, CLI
management, SNMP queries and traps, and other management functions.
Mgmt 2Mgmt 1Mgmt 0
Mgmt 2Mgmt 1Mgmt 0USBAlarmConsole
System
Power
On
Stby
Stby
Dis
LINK ACT LINK ACT
PWR H/S
Figure 2 - 23. Acme Packet 6100 Network Management Ports
Ethernet LED Each network management Ethernet port has two integrated LEDs: one LED
indicates Link, and the other indicates Activity. The LED pair is located
directly above its associated port.
Link LED
Activity LED
Figure 2 - 24. Acme Packet 6100 Network Management Ethernet Port
Link LED The link LED is located to the top left side of the network management
Ethernet port. This LED illuminates yellow when a link has been established
between the link partner device and the Acme Packet 6100.
Activity LED The activity LED is located at the top right side of the network management
Eth
ernet port. The activity LED illuminates green when an Ethernet
connection has either transmit or receive packet activity.
Upon initial bootup of the Acme Packet
6100, the network management
Ethernet ports are not configured. You must first connect to the Acme Packet
6100 over a serial connection before you can configure the management
7 Ground
8 Ground
Table 2 - 3. Acme Packet 6100 Alarm Port Pin-Outs (Continued)
Pin Number Signal Name/Description