User`s guide

14 T
URTLE
B
EACH
S
YSTEMS
I
NSTALLING THE
CD-ROM A
UDIO
C
ABLE
The Montego II comes with an audio connector cable — one end is keyed
(MPC-2), the other is not (Sony). All CD-ROM drives that adhere to the
MPC-2 (Multimedia PC) standard have an MPC-2 jack.
Connect the MPC-2 connector to your CD-ROM drive. Then attach the
Sony connector to the Montego II.
When connecting the CD-ROM audio cable, note that:
The audio cable should be plugged into the CD-ROM drive first; then
the other end of the interface should be plugged into the appropriate
connector on the Montego II sound card. Make sure that you are
plugging the audio connector into the 4-pin header labeled “CD IN.”
On the cable, “white” is “left” and “red” is “right.”
When connecting the cable to the Montego II, the red wire should be
on the right (white should be closest to the slot cover.)
The next step is driver installation and configuration.
P
ROCEED TO THE CHAPTER THAT APPLIES TO YOUR SYSTEM
:
Windows 95
&
98 Installation
Windows NT 4.0 Installation
MPC-2 Connector
(keyed)
Left
Ground
Ground
Right
Sony Connector
Left
Ground
Ground
Right