Instructions / Assembly

There is a risk of falling down and injury during the course of study.
Please wear a helmet and protective gear throughout the study.
Charging precautions
Maintenance
-5- -6-
Common Failures and Solutions
Thank you for your reading!
Electric scooter
Electric scooter
i11
▲Please read the user manual and get to know the performance of i11 intelligent electric
scooter before using the product. Don’t lend the scooter to the people who can't handle it.
i11
Strictly abide by local laws and regulations
and traffic laws.
Do not ride this scooter under the condition of
low visibility.
Do not use this car to do stunt, wheel or take-off, it will
increase the probability of injury and damage to the
scooter. Do not carry passengers.
When charging the electric scooter i11, please pay attention to the following
points.
1) Ensure that it is charged in dry and clean environment, the input voltage is
guaranteed between 110v-240v and the other end connects the charging port
of i11 electric scooter. The red light indicates the scooter is being charged.
2) The indicator light of the charger shows the green light, indicating that the
charging is completed.
3) Don’t turn on the scooter during charging for your safety.
4) Disconnect the scooter from the charger when the charging is complete.
1) Battery maintenance: In order to guarantee the battery life, when the
battery level is low, please charge the scooter timely (Note: When it is not in
use for a long time, it is recommended that charge it once a month), If you
want to check or replace the battery, please do it with the assistance of
professionals. The most suitable temperature of the battery storage is 15℃
-25℃; don't use and place the scooter when the environmental temperature is
higher than 40℃, in order to avoid the lithium battery's failure, and even lead
to the combustion. Do not place the scooter in the car during the hot seasons,
because it may lead to the lithium battery's failure or even the combustion.
2) Tire maintenance: In order to guarantee the tire life, please check the tires
of the scooter regularly. Once the wheel is abnormal, please repair or replace
timely, so as not to cause unnecessary damage during the riding.
3) Appearance maintenance: Swab the scooter body with water or mild
detergent, it will make your scooter clean. Please do not clean the scooter
with irritating potions or any chemical reagents.
1)The display board is working but the motor doesn’t work.
Reason analysis Solutions
a.The break handle
is damaged
c.The motor is
damaged
b.The speed regulating
steering handle is
damaged
2)Charging doesn’t work
Reason analysis Solutions
a.The battery charging
port is loose
b.The connection of the
charger plug is not well
a.Change a good charging port
b.Change a good changer connector.
3）Can’t turn on the scooter
Reason analysis Solutions
a.The battery is dead a.Charge the scooter for 1-2 hours according to the user manual.
b.The power button is
out of order
b.Check the power button which has got stuck or not.
a. Pull out the socket of the break handle (normally open type
brake handle), if the motor works, then it is the failure of break
handle, should replace the break handle.
b.Firstly check the speed regulating steering handle and motor’s hall
switch are short circuit or not. Generally it is easier to cause the joint short
circuit after rain affected with damp, so notice the short circuit of steering
handle and the motor hall switch. Otherwise there will be a continuous
damage of the replacement controller!
c.If the motor doesn’t turn, please inspect the motor’s hall
switch and turning handle’s signal. Once the power-on, the
controller shell is very hot, generally it is short circuit of the
controller internal power tube, should immediately cut off the
power.