Users Manual

Installation

The Pursuit wireless keypad is designed to be placed on the driver’s door “B

Pillar.” The rear slanted keypad should be places on the door pillar with the

keypad angled to the rear.

Clean and prep the installation area with a isopropyl alcohol based solution.

Allow the surface to dry completely before placing the keypad on the pillar.

Remove the red plastic backing from the adhesive pad on the rear of the

keypad. Place the keypad on the door pillar so that the keypad is angled

(Slanted) to the rear. Press rmly for 60 seconds to ensure the adhesive

properly adheres to the vehicle.

Programming

Locate the valet override button inside the vehicle. The vehicle’s door must be

open until programming is complete.

To Program the keypad:

1. Set the vehicle’s ignition to the ON position.

2. Press and release the valet override button three (3) times. The

system will beep one (1) time to conrm it has entered remote

programming.

3. Press and release the 7/8 and the 9/0 buttons. The system will

beep one (1) time to conrm the keypad has be programmed

successfully.

Note: The security system can store up to four (4) remote controls in its

memory banks. This can be any combination of four (4) keypad or key

chain remote controls. Any remote control programmed after four (4) will

automatically delete the oldest remote control in the memory bank.

Programming Personal Pin Code (Optional)

The keypad master unlock code cannot be changed or deleted. The keypad

can learn and store a personal pin code. This code can be changed at any

time.

To Program a Personal Pin Code:

1. Enter the ve (5) digit master code.

2. Within ve (5) seconds press and hold the 1/2 button for one (1)

second. The keypad LED will ash two (2) times.

3. Within ve (5) seconds, enter the new Personal Pin Code. The

keypad LED will ash two (2) times to conrm the Pin Code has

been stored.