INSTALL GUIDE WIRELESS KEYPAD ADVENTPRODUCTS.
Installation Installation The Pursuit wireless keypad is designed to be placed on the driver’s door “B Pillar.” The rear slanted keypad should be places on the door pillar with the keypad angled to the rear. Clean and prep the installation area with a isopropyl alcohol based solution. Allow the surface to dry completely before placing the keypad on the pillar. Remove the red plastic backing from the adhesive pad on the rear of the keypad.
Using Your Remote Control Locking the Vehicle To lock the vehicle, exit the vehicle, close all doors, then press and release the 7/8 & 9/0 buttons at the same time. The parking lights will flash one (1) time, indicating the system is armed, has locked the doors (if equipped and connected) and activated the starter disable feature. The LED status indicator will blink steadily, once per second. NOTE: The system is equipped with a feature called Silent Choice.
Voxx Electronics Corporation. Customer Service 1-800-225-6074 www.AdventProducts.com FCC COMPLIANCE This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions: 1. 2. This device may not cause harmful interference, and This device must accept any interference received, including any interference that may cause undesired operation.
