Owner's Guide
Table Of Contents
- Congratulations
- Important information
- Getting Started
- Responder LE 2-Way Remote Control
- Control Center
- Using your System
- Basic Commands (Direct Access)
- Advanced Commands: (Level 1)
- Advanced Commands: (Level 2)
- Advanced Commands: (Level 3)
- Advanced Commands: (Level 4)
- Remote Control Configuration
- Alarm Features
- Remote Start Features
- Remote and System Operations
- System Expansion Options
- Battery Information
- Battery Information (1-way)
- Glossary of Terms
- Patent Information
- Government Regulations
- Warning! Safety First
41
© 2021 Directed. All rights reserved.
Battery Information (1-way)
The 1-way remote controls are powered by one 3V coin cell lithium
battery (RPN* CR-2032) that can be purchased at most retailers.
When the battery begins to weaken, the operating range will be
reduced.
Battery Replacement
1- Unscrew the hardware on unit rear and remove from housing (if
present).
2- Use a small flat blade screwdriver and insert it into the slot located
along the bottom of the remote, near the key ring. Carefully
pry open
the case.
3- Gently
slide out the used battery/batteries to remove it from the
holding clip.
Orient the new battery for the correct polarity and insert
into holding clip.
4- Realign the case parts and snap together by pressing firmly and
evenly on the front and back.
Reinstall screw (if present).
Battery Disposal
Directed cares about the environment. If you need to dispose
of the battery, please do so in accordance with your munici-
pal requirements for battery disposal.
* RPN (Replcement Part Number).