Owner's Guide
Table Of Contents
- Congratulations
- Important information
- Getting Started
- Responder LE 2-Way Remote Control
- Control Center
- Using your System
- Basic Commands (Direct Access)
- Advanced Commands: (Level 1)
- Advanced Commands: (Level 2)
- Advanced Commands: (Level 3)
- Advanced Commands: (Level 4)
- Remote Control Configuration
- Alarm Features
- Remote Start Features
- Remote and System Operations
- System Expansion Options
- Battery Information
- Battery Information (1-way)
- Glossary of Terms
- Patent Information
- Government Regulations
- Warning! Safety First
33
© 2021 Directed. All rights reserved.
Note
Turbo Timer must be turned on by an authorized Directed
dealer.
Note
For Turbo Timer Mode on manual transmission vehicles fol-
low the directions in the MTS Mode (Manual Transmission
Start) section with the door open and in step 3 send the
Timer Mode command from the remote control.
Remote Start Faults
For user safety, the system must be properly configured or remote start
will not activate. The Remote Start Fault output (
AUX
LED on and long
fault tone) may be caused by any of several configuration issues. If the
remote start fails to activate, refer to the following table for the com-
mand type and parking light flashes that will identify the configuration
issue and solution.
Flashes * Possible Fault Solution
5 Brake ON Release Foot Brake
6 Hood Open Close Hood
7 After performing Remote Start
command - MTS not enabled
After performing Timer Start or
Smart Start command
Enable MTS Mode
Check all Solutions
8 Toggle Switch OFF Turn Switch ON
9 Start Valet is active Turn off Start Valet
None Alarm is Triggered Disarm or Reset Alarm
* Refers to the number of parking light flashes.