Owner's Guide
Table Of Contents
- Congratulations
- Important information
- Getting Started
- Responder LE 2-Way Remote Control
- Control Center
- Using your System
- Basic Commands (Direct Access)
- Advanced Commands: (Level 1)
- Advanced Commands: (Level 2)
- Advanced Commands: (Level 3)
- Advanced Commands: (Level 4)
- Remote Control Configuration
- Alarm Features
- Remote Start Features
- Remote and System Operations
- System Expansion Options
- Battery Information
- Battery Information (1-way)
- Glossary of Terms
- Patent Information
- Government Regulations
- Warning! Safety First
21
© 2021 Directed. All rights reserved.
Keypad Lock
Options: OFF, Auto
When OFF, the buttons do not lock and always perform a command
when pressed. When set to Auto, the remote buttons lock after a 20
second lapse between buttons presses to prevent unintentional opera-
tions. If a button is pressed when locked the a fault tone plays as an
alert. The 1-way companion emits the fault tone only.
To unlock the buttons, press the
AUX
button followed by the
AUX
AUX
button.
The confirmation LED’s flash and tones play to confirm unlocking.
Auto unlocking
After turning the ignition off, a message to the Responder LE will
unlock the keypad buttons until the next command is performed.
If Auto Unlocking is not desired this message can be turned off
by an authorized Directed Dealer.
Page Mode
Options: Power Save 1, Power Save 2, ON, OFF
Paging is how the Responder LE remote monitors your system’s mes-
sages. Power Save extends battery life by turning paging off after one
week if the remote control is not used during this period. Just press any
button to resume system monitoring. Power Save 2 is for maximum bat-
tery life and will monitor the system only when remote start has been
activated. Caution: Alarm trigger messages will not be received when
remote start is off. When set to ON it wakes up every few seconds to
listen for pages from the system. When set to OFF it does not wake up
to receive remote start or alarm trigger pages.
Note: When off, responses are still received when a command is
performed but alarm trigger pages will not be received.