Owner's Guide

Table Of Contents

in the following command descriptions that address these faults

or go to Feature not Available under the “Remote and System

Operations” on page 34 for details.

** Remote Start feature not available when the Remote Start status is

incorrect upon receiving the command. (Example: Runtime Reset

command received when remote start is off).

Refer to the notes included in the command descriptions that ad-

dress these faults or go to Remote Start Faults under the “Remote

Start Features” on page 28 for more details.

Basic Commands (Direct Access)

Arm

Press and release

AUX

The alarm arms, doors lock (if connected), and the siren chirps and

parking lights ﬂash once. The remote control Arm LED and beeps play

to conﬁrm. If Valet Mode* is ON, the doors lock and the Arm LED and

a fault tone plays. Exit Valet Mode to arm the alarm normally.

If a Trigger Zone Fault is detected the siren chirps once again and the

remote will emit a Trigger Zone Fault Report**, the Arm LED and a

fault tone plays.

To Arm and Panic

Press and hold

AUX

The alarm arms (or locks in Valet) and, after two seconds, sounds

the siren and ﬂashes the parking lights. The remote control’s con-

ﬁrmation LED’s ﬂash and siren tones play to conﬁrm. Press the

AUX

button to stop the output.