Quick Installation Guide

2
1 Introduction
A typical NoTraffic installation consists of one Sensor Unit (SU) for each
intersection approach (typically 4). and one control unit (CU) installed
inside the cabinet and connected to the traffic controller.
One of the Sensor Units per intersection, is a V2X / DSRC unit, which
uses Vehicle to Infrastructure communication protocols, enhancing
performance of the entire system, by added connected vehicle tech.
Identify this unit, according to label on box and added hardware
(antennas, surge suppressors and short ground cables), for further
reference (below).
V2X sensor Unit
Non-V2X sensor Unit