Specifications

10
Selecting eects and adjusting the parameters - [PDL],
[AMP/DR], [CAB], [NR], [MOD], [DLY], [REV]
Select an eect to use in each category and set the parameter.
1. Select the category with the CATEGORY selector.
2. Select the eect with the  or  buon.
The program/value display will indicate an abbreviation of the
eect name and the Tuner

LED will light up.
For the eects and parameters that you can select, please refer
to the “Appendices” section on page 64.
When you select an eect, the StompLab automatically sets the
parameters of that eect to the most eective values.
By adjusting the parameters, you can tweak your sound to
what you have in mind.
When WAH is selected in the [PDL] category, the
expression pedal will automatically be set as the wah pedal.
To turn an eect on/o, press both the  and  buons
simultaneously. When an eect is on, the eect name is
shown, and when an eect is o, the display indicates “oF”.
3. Set the eect parameter with the VALUE 1 knob and VALUE
2 knob.
As you turn a knob, the program/value display will indicate
the values. For VALUE 1 the Tuner center LED will light up or
blink and for VALUE 2 the Tuner # LED will light up or blink.
For the eect parameters that are assigned to each knob, please
refer to the “Appendices” section on page 64.
[Lo] and [Hi] are part of the [AMP/DR] parameter. If
[AMP/DR] is turned o, the eect will be disabled. Also,
you can set the volume level of the program with the
[AMP/DR] VALUE 2 knob (LEVEL).
For noise reduction, select [NR] with the CATEGORY
selector and adjust the sensitivity with the VALUE 1
knob. Adjust the noise reduction sensitivity so that you
don’t hear noise (hiss) when you’re not playing your guitar.
Depending on the guitar that you’re using, sustained
notes may be cut o if you raise the noise reduction value
excessively. This parameter should be adjusted so notes
ring out naturally.
Setting the expression pedal
Assigning parameters to the pedal
To assign parameters to the pedal, set them in the edit mode.
1. Enter the edit mode.
2. Display the eect parameter value that you want to use with
the expression pedal on the program/value display. Check that
the tuner center LED or tuner #LED is blinking.
If the tuner center LED or tuner #LED does not blink, you
cannot assign the parameters to the expression pedal.
3. Press the pedal seing buon.
“CP” will appear briey on the program/value display and the
eect parameter can be used by the expression pedal.
If the eect parameter is set as the target function of the
expression pedal, the eect of the target function will turn
on automatically.