User Manual

9
Tuning procedure
1. The Auto Chromatic Tuner will be activated when the StompLab
is bypassed or muted.
If you want to tune silently, such as during a live
performance, simply mute the StompLab.
2. Play a note on your bass and the program/value display will
indicate the name of the closest note.
Note names are indicated as follows.
C C# D D# E F F# G G# A A# B
Note name
Display
3. If your bass is sharp (pitch too high), the Tuner # LED will light
up. If your bass is at (pitch too low), the Tuner

LED will light
up. In either case, the brightness of the LEDs will indicate how
far either has veered.
When in tune, both the Tuner center LED will light up.
Adjusting the tuner calibration
You can adjust the reference pitch of the internal tuner (piano
center frequency A). You can calibrate this reference pitch in a
range of 438Hz–445Hz.
When you turn o the power, the calibration adjustment that you
made will be discarded and the StompLab will automatically
be set to 440Hz.
1. Change the reference pitch with the  or  buon when the
tuner is starting up.
The program/value display will indicate a reference pitch
(38-45: 438-445Hz).
Creating your sound (Edit mode)
The Edit mode is where you can set the eects that are used in each
category, such as [PDL] (PEDAL), [AMP/DR] (AMP/DRIVE), [CAB]
(CABINET), [NR] (NOISE REDUCTION), [MOD] (MODULATION),
[DLY] (DELAY) and [REV] (REVERB).
Signal ow
PEDAL
AMP/DRIVE (Lo/Hi - Mid)
REVERB
DELAY
MODULATION
NOISE REDUCTION
VOLUME PEDAL
CABINET
The VOLUME PEDAL can be used when the target function of
the expression pedal is set to VOLUME. (Page 10 “Assigning
volume to the pedal”)
Entering Edit mode
1. In Program select mode, press the EDIT buon. You will enter
the Edit mode and the EDIT LED will light up.
Selecting eects and adjusting the parameters - [PDL],
[AMP/DR], [CAB], [NR], [MOD], [DLY], [REV]
Select an eect to use in each category and set the parameter.
1. Select the category with the CATEGORY selector.
2. Select the eect with the  or  buon.
The program/value display will indicate an abbreviation of the
eect name and the Tuner

LED will light up.