Specifications

13
Adjusting the high-frequency tone (Presence)
HolddowntheCABINETon/offswitchforaboutonesec‐
ondtoenterOPTIONparametersettingmode,andthen
turntheTREBLEcontrol.
5. Sel
ectandadjusttheeffectsofothersectio
ns.
Forexampleifyouwanttoadd TAPEECHO,turnthe
DELAYselectortoselectTAPEECHO.
IftheselectorisalreadypositionedatTAP
EECHO,turnit
tosomeother delaytypeandthenbacktore‐selectTAPE
ECHO.
UsetheTAPswitchorEDITknobtosetthedelaytime,de‐
laylevel(themixamountofdelaysound),andfeedback.
To set the delay time
PresstheTAPswitchtwice (thetime willbeset tothein‐
tervalthatwasusedtopresstheswitch).
To adjust the delay level or feedback
Delaylevel:TurntheEDITknob.
Feedback:HolddowntheTAPswitchandturntheEDIT
knob.
Fordetailsontheeffecttypes,referto“A b ou t theamp
models,cabinetmodels,andeffecttypes”(p.15).
HINT: Ifyou’veselectedapedaleffect,itmightbeeasierto
makeadjustmentsifothereffects areno tbeingap‐
plied.Ifso,adjustthepedaleffectafteryou’vespec
i‐
fiedtheampmodelandcabinetmodel ,butbefore
youadjustsettingsforothereffects.
6. Whenyou’vecomeupwithasou
ndthatyoulike,saveit
asaprogram.
Fordetails,referto“Savingaprogram”(p.15).
NOTE: Ifyouswitchtoadifferentprogramorturnoffthe
powerbeforesaving,thechangesyou’vemadewill
bediscarded,and thesettingswillreverttotheir
originalstate.
Parameter original value indication
Thisisawayforyoutochecktheoriginalvalueofaparame‐
ter;i.e.,thevalue thatwassavedinthepresetprogramor
userprogram.
Whenyouʹreus ing aknobtoeditth
evalueofaparameter,
thedecimalpointinthe lowerleftofthebank/valuedi splay
LEDislit‐upmomentarilywhentheeditedvaluematchesthe
originalvalue.
HINT: Youcantakeadvantageofthisoriginalvalueindication
tofindouttheactualsettingsofaprogramthatyo u 
like.
NOTE: ThesettingsoftherearpanelLEVELknob,SPEAKER
LEVEL,TotalEqualizer,andAMP/LINEswitchset‐
tingsarenotsaved,an
dwillnotbeshownbytheorig‐
inalvalueindication.Norwilltheoriginalvalueofthe
SPEEDparameterorTIMEparameterbeshownwhen
youusetheTAPswitchtosettheSPEEDparameteror
TIMEparameter.