Owner`s manual

JamVOX Effect guide
54
13. HD-ROOM Mono in/Stereo out 1
This is a high-quality reverb that faithfully simulates the reverberation of a typical room. By adjusting the parameter settings you can simulate the
acoustics of a wide variety of rooms.
PRE LPF [0.0…10.0]
Sets the tone of the input.
PRE DELAY [0…1360 ms]
Sets the initial delay before the reverberation begins.
TIME [0.0…10.0]
Sets the reverb time.
HI DAMP [0.0…10.0]
Adjusts the attenuation of the high-frequency range.
LO GAIN [-12.0…6.0 dB]
Sets the gain of low range.
MIX [0.0…10.0]
Adjusts the mix balance between the reverb sound and direct sound. With a setting of 10.0 you will hear only
the reverb sound.