Owner`s manual

JamVOX Effect guide
30
6. DUO PHASE Mono in/Mono out 2 (Mode=SERIAL1, SERIAL2), Stereo in/Stereo out 2 (Mode=PARA1, PARA2, PARA3)
This is an amazing phaser that provides two six-stage phasers; PHASER 1 and PHASER 2. They can be connected in series (to make a pseudo-
twelve-stage phaser!) or in parallel, and you can also synchronize or de-synchronize the two LFOs.
SPEED1 [0.100...10.00 Hz]
Adjusts the modulation speed of PHASER 1.
DEPTH [0.0...10.0]
Adjusts the modulation depth of PHASER 1/2.
RESONANCE [0.0...10.0]
Adjusts the amount of resonance for PHASER 1/2.
SPEED2 [0.100...10.00 Hz]
Adjusts the modulation speed of PHASER 2.
NOTE: This will not function if “MODE” is set to SERIAL2, PARA2, or PARA3.
MODE [SERIAL1, SERIAL2, PARA1, PARA2, PARA3]
Specifies the connection and LFO for PHASER 1/2.
SERIAL1: PHASER 1/2 are connected in series.
SERIAL2: PHASER 1/2 are connected in series and their LFOs are synchronized to create a pseudo-twelve-
stage phaser.
PARA1: PHASER 1/2 are connected in parallel (Stereo mode).
PARA2: PHASER 1/2 are connected in parallel, and their LFOs are synchronized (Stereo mode).
PARA3: PHASER 1/2 are connected in parallel, and their LFOs are synchronized in opposite phase (Stereo
mode).
NOTE: If SERIAL2, PARA2 or PARA3 is selected, the speed is adjusted by the “SPEED 1”.