Owner`s manual

E. Modulation Effects
25
E. Modulation Effects
Here you can make settings for a modulation effect. You can choose one of twelve types.
Parameters marked with can be controlled by an optional Korg EXP-2 foot controller connected to the JamVOX monitor.
Parameters marked with can be controlled by an optional VOX VFS-2 foot switch connected to the JamVOX monitor.
For details on how to assign a parameter to the foot controller or foot switch, refer to “Option pedal/switch settings” (See JamVOX owner ’s manual
“Option pedal/switch settings” on page 32).
1. CLASSIC CHORUS Mono in/Mono out 1 (Mode=1,3), Mono in/Mono out 3 (Mode=2)
This models a chorus unit that has two modes (chorus and vibrato), and is best-known for being built into a guitar amp. There’s no parameter to switch
between chorus and vibrato, but you can use the “”SPEED and “DEPTH” knobs to create either of these sounds, giving you an even broader range of pos-
sibilities than the original unit! The output vibrato mode allows you to create vibrato (pitch modulation) by outputting just the effect sound.
SPEED [0.100...10.00 Hz]
Adjusts the modulation speed.
DEPTH [0.0...10.0]
Adjusts the modulation depth.
MANUAL [1.0...10.0]
Adjusts the center frequency of the sweep. “MANUAL” has no effect if “DEPTH” is set to 10.0 .
MODE [1, 2, 3]
Selects the output mode.
1: Mono output.
2: Stereo mode in which the effect is panned right, and the dry sound panned left.
3: Vibrato mode, in which only the effect sound is output. Setting “MANUAL to 10.0 will minimize the delay
of the output sound.