User Manual
Table Of Contents
- English
- Français
- Introduction
- façade et face arrière
- Préparations
- Fonctionnement de cet appareil
- Utiliser les effets delay
- Sauvegarder les réglages d’effet
- Utiliser des effets Looper
- Utiliser une pédale d’expression
- Régler le mode de contournement (‘Bypass’)
- Contournement fluide
- Changement de programme fluide
- Maintien des réglages de paramètres
- Fonction “Kill Dry”
- Verrouillage des contrôleurs
- Sélection du type de piles
- Liste d’effets
- Rétablir les réglages d’usine
- Dépannage
- Fiche technique
- Deutsch
- Preset program chart
19
Troubleshooting
Power won’t turn on
• Is the AC adapter connected to the rear panel DC9V jack?
• Is the AC adapter connected to an AC outlet?
• Could the AC outlet be faulty?
• Could the AC adapter be malfunctioning?
• Are the negative and positive orientation of the batteries
correct?
• Are the batteries charged?
• Is the cable connected to the INPUT terminal correctly?
No sound
• Is your instrument correctly connected to the DelayLab’s
INPUT jack?
• Could the cable be broken?
• Could the volume be turned down on the instrument
that’s connected to the INPUT jack?
• With the KILL DRY function enabled, is the Effect off
(bypass)?
Loop won’t play back
• Is the value of INTENSITY (loop level) low?
When the lifespan of the batery is short
• Is the setting of the battery type correct? Select either
alkaline battery or nickel metal-hydride battery. (Page 14
“Setting the battery type”)
Effects aren’t heard
• Is the effect turned on?
• Is MIX assigned to the pedal that’s connected to the
CONTROL PEDAL jack?
Something is wrong with the sound
• Check the effect settings.
Using the pedals, buttons, selectors, or knobs
does not change the sound
• Could the effect be turned off?
• Could the Key Lock function be enabled?
Power turns off unexpectedly
• The DelayLab is equipped with an auto power-off
function that automatically turns off the power (low-
power consumption mode) when the unit hasn’t been
used for 4 hours. If you want to disable the Auto Power-
Off function, please refer to “Disabling the auto power-off
function” on Page 9.