User Manual

11
2. Press the REC/PLAY/OVERDUB switch when playing
a phrase that you want to loop. Recording ends and the
LED lights up green.
3. To overdub, press the REC/PLAY/OVERDUB switch
where you want to start playing. The LED lights up
orange.
TIP: If the TRIGGER switch is pressed while recording,
playing back or overdubbing, it will reset to the
beginning of the phrase.
4. Press the REC/PLAY/OVERDUB switch to end
overdubbing at the desired location. The function
switches to playback and the LED lights up green.
5. Press the STOP/CLEAR switch to stop playback. The
LED lights up green to indicate that the phrase has been
recorded. Press the REC/PLAY/OVERDUB switch to
start playback again. Also, if the STOP/CLEAR switch
is pressed for 2 seconds or more when playback of the
phrase has stopped, the recorded phrase is deleted and
the LED turns off.
TIP: If the REVERSE switch is pressed, the phrase
is played in reverse and the LED lights up.
REVERSE cannot be switched while recording or
overdubbing.
Using a connected pedal
You can control the effect parameter and volume with an
external expression pedal.
The pedal settings can be saved for each program.
)Page 9 “Saving edited effects”
Assigning functions to a pedal
1.
Turn off the power off the DelayLab and connect the
expression pedal.
2. Connect a cable to the INPUT (L/MONO) jack and turn
on the power.
3. Press the PEDAL ASSIGN button.
The LED lights up green and “PdL
_
” appears on the
display.
4. Adjust the Edit knob to set the sound of the full heel
position of the pedal.
5. Press the PEDAL ASSIGN button.
“PdL
–
” appears on the display.
6. Adjust the Edit knob to set the sound of the full toe
position of the pedal.
7. Press the PEDAL ASSIGNbutton.
The LED lights up red.