User Manual
Table Of Contents
- English
- Français
- Introduction
- façade et face arrière
- Préparations
- Fonctionnement de cet appareil
- Utiliser les effets delay
- Sauvegarder les réglages d’effet
- Utiliser des effets Looper
- Utiliser une pédale d’expression
- Régler le mode de contournement (‘Bypass’)
- Contournement fluide
- Changement de programme fluide
- Maintien des réglages de paramètres
- Fonction “Kill Dry”
- Verrouillage des contrôleurs
- Sélection du type de piles
- Liste d’effets
- Rétablir les réglages d’usine
- Dépannage
- Fiche technique
- Deutsch
- Preset program chart
10
VOX DelayLab Owner’s manual
Do not disconnect the cable from the INPUT (L/
MONO) jack while saving an effect.
Using looper effects
This unit is equipped with three looper types which include
standard, vintage and custom. A delay effect can be applied
and recorded using each input sound.
If the Looper is selected, the TAP/BANK UP switch and
channel switch functions are switched off and the program
cannot be recalled with a Channel switch.
Channel switch function
a cb d
a. REC/PLAY/OVERDUB
Use to playback the looper recording and start overdubbing.
b. LOOP STOP/CLEAR
Use this function to stop or clear playback of a loop phrase.
c. REVERSE
Use this function to reverse playback of a loop phrase.
d. TRIGGER
Use this function to reset playback of a loop phrase to the
beginning of the recording.
Setting procedure
1.
Select “LOOPER” on the Type Selector knob.
2. Press the CATEGORY button and select the looper type.
Green: Standard (digital delay)
Orange: Vintage (analog delay)
Red: Custom (space delay)
3. Adjust the tone quality and volume with the TIME knob,
FEEDBACK knob, TONE/SPEED knob or MIX knob.
4. To save an edited tone quality, press the WRITE button. If
the WRITE button is pressed while the display is blinking,
the save function will start. “CP” appears when the save
function is complete. To cancel, press the CANCEL button.
5. Adjust the playback volume of the loop phrase with the
INTENSITY knob.
TIP: If Custom is selected, the loop phrase sound
decreases each time overdubbing is performed.
TIP: You can assign the knob settings with the pedal.
Operating procedure
1.
If the REC/PLAY/OVERDUB switch is pressed, recording
starts and the LED lights up red.