User Manual

- 8 -
Tip
Ifyoudecidetocancelinitializationatthispoint,presstheTAP
button.
3. HolddowntheBANKbuttonforatleast2seconds(untilthebutton
changesfromblinkingtolit).
AftertheBANKandchannelbuttonschangefromblinkingtolit,
initializationbegins.Initializationiscompletedafterabout1to2
seconds,andtheampentersthepresetprogramsmode.
 Neverturnoffthepowerwhileinitializationisinprogress.
Using the tuner
Thetunerfunctionallowsyoutoeasilytuneaguitarthat’sconnectedto
theINPUTjack.
1. HolddowntheTAPbuttonfor
atleast1second.
Alleffects,exceptnoise
reduction,arebypassed,andthe
tunerfunctionisturnedon.
2. Playanyopenstringontheguitar.
 Becarefulnottoplayanyoftheotherstrings.
3. Roughlytunethestringuntil
thebutton(BANKandchannel
buttons)indicatingthestringthat
wasplayedlightsup.
4. Whilecheckingtheeffect
selectionbuttons,correctly
tunetheguitar.
5. PresstheTAPbuttontoturn
offthetunerfunctionand
cancelbypass.
Sharp
Slightly sharp
In tune
Slightly flat
Flat
Saving a program
Afteradjustingthevariousknobsandbuttonsonthetoppaneltocreate
yourdesiredsound,itcanbesaved(written)asauserprogram.
Tip
Whensavingprogramstochannelswithinthesamebank,startthe
procedurefromstep3.
1. HolddowntheBANKbuttonforatleast0.5second.TheBANKbuttonblinks.
2. PresstheBANKbuttontoselectthebankwheretheprogramwillbesaved.
Tip
Tocancelthewriteoperation,presstheTAPbutton.
3. Holddownthechannelbuttonofthesavelocationforatleast2seconds
(untilthebuttonchangesfromblinkingtolit).Theprogramissavedto
thechannel,andthebankandchannelforthesavelocationareselected.
 Anyprogrampreviouslysavedatthatlocationisoverwritten.
Inotherwords,theprogrampreviouslysavedatthelocation
selectedinstep3iserased.
 ThebypasssettingoftheeffectandthePOWERLEVELsetting
arenotsavedwiththeprogram.
 If,whilecreatingasoundinthepresetprogramsmodeorthe
userprogrammode,youswitchtoanotherprogramortomanual
modeorturnofftheampbeforesavingthesoundthatyouare
creating,thechangesthatyoumadewillbelost.
Restoring the factory settings
Here’showtorestoreallsettingsoftheVT100Xtotheirfactory-setstate.
 Whenthisoperationisdone,allprogramssavedtochannelsaswell
asallsettings,suchascustomampsettingsstoredfromtheEditor/
Librariansoftware,willberesettothefactorydefaults.
1. Turnoffthepower.
2. WhileholdingdowntheCH1andCH4buttons,turnontheamp.After
theBANKandchannelbuttonsblink,releasethepressedbuttons.