User Manual

- 12 -
1. HolddowntheTAPbuttontobypasstheeffects(thetunerfunction
isturnedon).
2. TurntheVALUE1knobtoadjustthesensitivityofnoisereduction.
Turntheknobtotherighttoincreasethenoise-reducingeffect.When
thisknobisfullyturnedtotheleft,noisereductionisturnedoff.
 Dependingonyourguitar,increasingthesensitivityofnoise
reductiontoomuchmaycauseinterruptionsinthesound.
3. PresstheTAPbuttontocancelbypass.
Global noise reduction setting
Thenoiselevelchangesdependingontheguitarbeingused,thepower
supplyandotherexternalfactors.Whentheoperatingenvironment
ischanged,overalladjustmentscanbemadewhilemaintainingthe
differentsensitivitiesspecifiedforeachprogram.
 Thissettingdoesnotaffectprogramsinwhichnoisereductionhas
beenturnedoff.
1. WhileholdingdowntheTAPbutton,turnontheamp.
Theilluminationoftheeffectselectionbuttonsshowsthecurrent
setting.
Low
Medium
High
2. PresstheTAPbuttonorturntheVALUE1knobtochangethesetting.
3. Waitwithoutperforminganyoperationforafewseconds.
Thesetting
isapplied,andtheampautomaticallyreturnstonormaloperation.
4. DELAY
Thismodelsanacclaimedanalogtapeecho.Originally,echowascreated
byatapehead,andthedelaytimewasspecifiedbychangingthespeed
ofthemotor.
Button/Knob Parameter Effect
TAP TIME Adjuststhedelaytime.
VALUE1 LEVEL Adjuststhemixamountofthedelaysound.
VALUE2 FEEDBACK Adjuststheamountoffeedback.
REVERB effects
AdjustthemixamountofthereverbsoundwiththeVALUE1knoband
thereverbdurationwiththeVALUE2knob.
1. ROOM
Thisreverbtypesimulatesatypicalroomthatcontainsnumerousearly
reflections.
2. SPRING
Thissimulatesthespringreverbthat’sbuiltintomanyguitaramps.
3. HALL
Thismodelsthereverberationandechoofalargeconcerthall.
4. PLATE
Thismodelsaclassicplatereverbunitusuallyfoundinrecordingstudios.
Noise reduction
Thisappliesanoise-reducingeffect.
 Aswithampsandeffects,noisereductionmustbesetforeach
program.If,whilechangingsettingsinthepresetprogramsmode
ortheuserprogrammode,youswitchtoanotherprogramorto
manualmodeorturnofftheampbeforesavingthesettings,the
changesthatyoumadewillbelost.
 Whentheampmodelischanged,thenoisereductionsettingis
returnedtothestandardsettingforeachamp.