Specifications

8
2.2 Jumper Description
You can change the SSC-5x86H's configuration by setting jumper
switches on the board. The board's jumpers are preset at the factory.
Under normal circumstances, you should not need to change the
jumper settings.
A jumper switch is
closed
(sometimes referred to as shorted with
the plastic cap inserted over two pins of the jumper). A jumper is
open
with the plastic cap inserted over one or no pin(s) of the
jumper. Figure 2.2 below shows different jumper settings which
will be used in this chapter.
CLOSED OPEN
1-2
1
2-3
1
1-2
1
2
3
2-3
1
2
3
2-4
1
2
3
Figure 2.2