User`s manual

~ 19 ~
˙Try a different PS/2 mouse at the console.
˙Make sure the mouse (at the console) is a true PS/2 mouse. A combo mouse will
not work just as long as it is set for PS/2 mode with the correct adapter. A
serial-only mouse with a combo mouse adapter WILL NOT work.
˙Check to make sure that the power cord is plugged in and its working properly.
Make sure the power switch is on.
˙ Reset the KVM08 by simultaneously pressing the Bank/SCAN and Channel
buttons on the front panel. Access the OSD menu again and it should have
re-detected all the active ports.
Q : When I switch from one port to another, mouse movement is completely erratic.
What do I do?
A : ˙ Reset the KVM 08 by simultane ously pressing the Bank/SCAN and Channel
buttons on the front panel. Access the OSD menu again and it should have
re-detected all the active ports.
˙Make sure you do not have more than one mouse driver. Make sure that driver is
either for a Standard PS/2 or Microsoft
®
compatible PS/2 mouse.
˙Avoid using a specialized mouse at the console such as a cordless mouse,
scrolling mouse or mice with more than 2 operation buttons. Non-standard mice
often use non-PS/2 proprietary mouse protocol.
˙Make sure you do not have any mouse drivers loaded in your config.sys or
autoexec.bat files.
˙Avoid moving the mouse or pressing the mouse buttons when switching ports.
˙Reset the mouse to resume proper mouse movement simply by unplugging the
mouse form the front of the KVM08 for about 2-3 seconds, and plugging it in
again.
Q : The wheel on the IntellMouse
®
does not work on my computer. Why?
A : ˙The integrated mouse conversion technology converts only the standard PS/2
signals which are the buttons and the x and y coordinate movement, but not the
wheel movement or wheel button. This is because the wheel button data use
non-PS/2 protocol.