User`s manual

OPERATION

~ 15 ~

˙Pressing the ESC key exits the current screen.

˙To view a different BANK, pressing the PAGE UP key goes to a previous BANK, while

the PAGE DOWN key brings you to the next BANK.

˙Once you have selected a computer on the menu, press ENTER to switch to that port.

˙Pressing the TAB key opens up the Function menu. In this menu, you can select the

SCAN TIME and DISPLAY TIME.

NOTE: If there are slave units present, the SCAN TIME and DISPLAY TIME settings are

set on the MASTER unit only, and need not be set on the slave units.

The Bank/SCAN Button:

Pressing the Bank/SCAN button cycles you through all the active BANKs (if there are

slave units present) and then puts the unit in AutoScan mode. If the unit is a single

MASTER unit, pressing the button immediately invokes AutoScan mode. This is evident

by a long beep, followed by two short beeps.

SCAN TIME:

Amount of time the KVM

08 stays one port

before switching to the next port when in

Scan Mode

DISPLAY TIME:

Amount of time the OSD Menu or Port

Name remains displayed on-

screen after

making a port selection

SCAN TIME:

DISPLAY TIME:

7sec 15sec 30sec 60sec

[ ]: SELECT

(INS): RENAME

(Enter): COMPLETE

(Esc): Exit