User manual

2
English
Parameters E1 settings T1 settings
Tone zone US US
Timing (Clock source) 0 0
LBO 0 0
Framing ccs esf
Coding hdb3 b8zs
CRC4 enabled Enabled Disabled
B-channels 1-15,17-31 1-23
D-channels 16 24
Switchtype euroisdn national
Signalling (Termination side)
pri_net(only
supports pri_
net)
pri_net(only
supports pri_net)
Group 1 1
Language EN EN
Receive Wink Timing 300 300
B. Connect Exchange Pro VIT1/E1 to the PBX
1. Connect the E1/T1 port on the Exchange Pro VIT1/E1 backplate
to the E1/T1 port on the PBX using the provided RJ-48 cable as
shown below:
2. If the provided cable is not applicable to your PBX, please refer to
Appendix D in the user manual to make an appropriate interface
or ask your reseller.