User guide
TIGER 260
85
TIGER 260
84
Connecting the Electronic Brush
and other accessories
Push the electrical suction tube into the
joint nozzle of the Electronic Brush or of
other accessories until it clicks into place.
Both devices are now ready for operation.
(FIGURE 7)
In order to detach the accessories, press
the release button on the lower side of the
electrical suction tube and take off the
accessory part. (
FIGURE 8)
Connecting
Pull the connecting cable out of the Tiger
260 and insert the plug into the mains
socket.
(FIGURE 9)
A marking on the mains cord indicates that
there are only a few centimetres left for the
cable to be fully paid out. The cable can be
wound up again without the need of
pressing an additional button. You just have
to slightly pull at the cable (2.5 cm). It will
then wind up automatically.
(FIGURE 10)
FIGURE 7
FIGURE 8
FIGURE 9
FIGURE 10
Tiger 260
Assembly & Use
Assembly & Use Assembly & Use
Working with the Tiger 260
Connecting the suction hose
Press the electrical suction hose onto the
suction socket of the Tiger 260 until the
connecting piece can be heard
to click into place. When doing so, please
take into account the position of the
contact clamps, since the electronic suction
hose can be assembled in one direction
only.
The hose is connected to the appliance by
means of a 360 degree joint. The joint
allows you to easily vacuum all around the
vacuum cleaner.
(FIGURE 3)
In order to detach the suction hose,
press the two release buttons and lift the
electrical suction hose off the Tiger 260.
(FIGURE 4)
Connecting the electrical suction tube
Push the electrical suction tube into the
connecting socket of the handle until you
hear the tube click into place.
(FIGURE 5)
In order to detach the electrical suction
tube, push the release button located on the
end of the suction hose and pull the
connecting pieces apart.
(FIGURE 6)
The Tiger 260 can only be used with the
electrical suction hose for the Tiger 260, not
with the hose of an older model.
FIGURE 3
FIGURE 4
FIGURE 5
FIGURE 6