User guide

 Pulilux PL 515
Assembly & Use
Fit the Kobold VK 140 to the joint on the
Pulilux PL 515.
(FIGURE 3)
The Kobold VK 140 will remain upright
when the joint is locked perpendicular.
(FIGURE 3)
 Switch off the appliances before and
always remove the plug from the power
supply before changing the pads. The
Pulilux PL 515 has a motor overload cut-
out, which triggers if the appliance
overheats. After removing the cause and
allowing the Pulilux PL 515 to cool down
for about 15 minutes, the Pulilux PL 515 is
ready to be used again. Always switch off
the appliance when cooling down.
 Use the Pulilux PL 515 only for dry
cleaning of hardfloors for domestical use.
Changing the pad modules
Choose the pads suitable for the floor to
clean
(see PAGE XX).
1. Press the opener button fully down to
release the handle.
(FIGURE 4)
2. Open the cowling. (FIGURE 5)
The Hard floor and Polishing Modules are
both dual-function:
Hard floor Module: combines cleaning bru-
shes and power pads
(see PAGE xx).
Polishing Module: combines polishing bru-
shes and polishing pads
(see PAGE xx).
FIGURE 3
FIGURE 4
FIGURE 5
 Pulilux PL 515
Technical specifications
PL 515
69
PL 515
68
Technical specifications
Appliance usable exclusively when connected to Kobold appliances.
Connects to the Kobold through a practical connection system.
Voltage 230V AC / 50 Hz
Power absorption 350 W
Maintenance free motor with drive and reduction by gears
Brushes set speed 1200 rpm
Working surface area 600 cm
2
Height approx. 99 mm
Weight 3.00 kg
Noise emission 85 dB with VK 140 system
(measured on hard floor in ideal conditions)
Protection level IPX 0
The identification details of the product are on the label on the rear side
of the appliance.
The manufacturer reserves the right to make any changes suggested by
developing technology, at any time and without prior notice.
Assembly & Use